C Developer & C++ Developer

Inteligentný freelancer, ktorý sa venuje vývoju od roku 2011. S technológiou C pracuje už 4 roky a rád by sa v nej naďalej zdokonaľoval. Na svojej súčasnej pozícii má na starosti programovanie vstavaných aplikácií na simuláciu elektroniky v aute. V minulosti mal na starosti aj menší tím mladších kolegov. S anglickým jazykom nemá problém.

HW/FW Developer (Freelancer):

• Developed various hardware and firmware projects as a freelancer
• End of Line Tester: Designed and implemented a tester with 20 channels for auto-ranging current measurement
• CAN FD Simulator: Created a simulator with 4 CAN FD channels for car electronics simulation, including speed, wheel angle, display backlight, battery, and ignition
• Power Waveform Generator: Developed a waveform generator for car component testing according to VW80000 norm
• OLED Rear lamp: Designed a rear lamp with 124 PWM channels for OLED display control

System Engineer (2015 - 2017):

• Worked on headlamp and rear lamp electronics
• Responsible for schematic capture, PSpice simulation, PCB layout, and C programming
• Involved in system integration, master unit interface, and CAN FD diagnostics

Firmware Developer (2013):

• Contributed to the development of a wireless internet access point PCB
• Conducted prototype PCB bring-up
• Developed ARM C code for IQ modulators and RF synthesizers
• Utilized oscilloscope, spectrum analyzer, and logic analyzer for testing and debugging

Software Developer (2011):

• Developed a Raspberry Pi-based server backup solution
• Created a datalogger PIC24 HAL library
• Implemented Bash scripts and worked with TCP/IP stack for networkin